After the edr1rxd1 water filter is installed, there is often a phenomenon that the water flow is getting smaller and smaller, why is this? Very often for reverse osmosis water purifiers water production becomes slower, most people habitually think that the RO membrane is clogged, however, after buying a new filter replacement, the water is still slow. In fact, there are many reasons why water purifiers become slower, not just because the membrane is blocked. The following small to explain the water purifier out of the water flow becomes small may appear for a variety of reasons.
1.refrigerator water filter
An activated carbon refrigerator water filter is equivalent to our body's "kidneys". The quality of water not only depends on the quality of the refrigerator water filter but also depends on whether the water purifier cartridge life expires after timely replacement. Cartridge use too long, if not timely replacement will cause clogging, water purifier water will be slower and slower, over time will also pollute the entire water purifier.
2.active cotton clogging
This situation is usually in the replacement of new activated carbon, carbon powder piled up together without flushing dispersion, after the water directly to the rear active cotton, resulting in the rear active cotton blocked blockage. For this reason, the ordinary granular activated carbon cartridge should not be too full, to ensure that there is a certain amount of filling space.
3. Lower temperature
The speed of the water purifier water production is related to the temperature, generally based on 25°C. For every 1°C reduction, the water production will be reduced by 3%. For this reason, the water purifier's water output speed drops by more than half in winter compared to summer. So in winter, the water purifier to do a good job to prevent cold and freezing measures.
4.pump booster small
Generally speaking, the use of more than two years of reverse osmosis water purifier or long-term operation of the reverse osmosis water purifier, booster pump life will be correspondingly shortened. An insufficient increase in booster pump will lead to raw water not reaching the water pressure of the RO membrane, thus affecting the water purifier's water output speed.
Usually, Checking the flow rate affecting the water filter can be done from the above four aspects. If you face with some factors that other than the above, it is better for you to call a professional repair person to visit your home to check and solve the problem.